![]() It was made in the early 1980s according to the SN. What is the right ratio for gas and oil I use 16:1 on my SXLAO, but I didnt know if that was the right relationship for this saw. Turn the screw to the left and note the engine performance. Homelite xl chainsaw fuel mixture Im currently working on a Homelite XL saw, the little one, and Ive rebuilt the carbohydrate right now. Set the high speed screw by adjusting the screw marked "H." Pull the trigger so that the throttle opens as wide as possible. Set the High-Speed Screw Adjust the Homelite chainsaw carburetor by turning the high- and low-speed screws as needed. Go back to step (4) and reset the idle speed.Begin by checking the saw's air filter.Before you start the saw, locate a small flat-bladed screwdriver.Place your left hand on the handle on top of the saw.īesides, how do you adjust a chainsaw carburetor?.Locate the two handles on the saw, the top and rear one. Plug the male end of the extension cord into a power outlet.Fill the oil reservoir with chain saw lubricant. Open the oil reservoir cap on top of the chainsaw.How do you start a Homelite 3514c chainsaw? How to Start a Homelite Chainsaw ![]() Keeping this in consideration, how do you adjust the carburetor on a Homelite Super XL?Ĭhanging the Carburetor Setting Turn the idle-speed screw counterclockwise, or to the left, in one-quarter turn increments until the engine speed reduces, the saw idles smoothly and the chain no longer turns. ![]() Turn the screw to the left and note the engine performance. Adjust the Homelite chainsaw carburetor by turning the high- and low-speed screws as needed.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |